AS OF APRIL 1 , 2019
SERVICE CALL FEE WILL BE $43.00 FOR THE CHARLOTTE COUNTY AREA
AND PARTS OF NORTH PORT.
ALL OTHER AREA YOU WILL NEED TO CALL.
SEVICE FEE IS DUE UPON ARRIVAL .
IF WE LOOK AT YOUR EQUIPMENT AND WE GIVE YOU AN ESTIMATE ON THE REPAIR OR MAINT AND YOU CHOOSE FOR ME NOT TO DO THE WORK . THERE WILL BE A DIAGNOSES FEE OF $30.00 ADDED
JUST TO MAKE IT CLEAR EACH PICE OF EQUIPMENT IS A SEPERATE JOB .
OUR SHOP RATE PER FLAT HOUR IS 85.00
FLAT RATE IS A BOOK THAT TELL REPAIR SHOPS WHAT IT SHOULD TAKE TO DO THE JOB THIS IS NOT ACTUAL TIME SPENT. IF THE BOOK SAYS 1.0 HR TO PREFORM THE TASK AND I TAKE MY TIME AND PREFORM THIS TASK IN 2.0 HOURS I ONLY CHARGE YOU FOR 1.0 HR.
HERE IS THE BASIC ESTIMATE FOR THE CHARLOTTE COUTY AND NORTH PORT
SERVICE CALL $43.OO
1ST 30 MIN $30.00
THIS IS WHAT YOU CAN EXPECT IF I DO NOT FIX ANYTHING BUT TELL YOU WHATS WRONG.
NOT KNOWING WHAT IS WRONG IS VERY HARD TO GIVE YOU A PRICE OVER THE PHONE.
i do not warrenty parts customer buy on line or from other retairers . to install these parts even if they do not work you still have to pay the labor to preform the job. if you do not understand this its always best to ask questions.
Pressure washers these days are not very expensive in fact you could buy a new one for under $200.00 and run at 3800 psi.
here is what i am trying to say
exsample: if you live in port charlotte
house call fee $43.00
1st 30min is diagnoses chg is $30.00
for a total of $73.00 and we haven't added any parts yet.
so figure it would pay you to buy a new one instead of fixing the old one instead of wasting the money to fix the old one.
So do a little bit of reserch berfore you stick alot of money into your pressure washer.
BASIC TUNE UPS - AVGERAGE PRICE 89.00 + PARTS. NOT FOR ALL
1. REPLACE MOWER DECK BELTS PRICE DEPENDS ON TYPE OF EQUIPMENT
2. Mechanical REPAIRS PRICE PER SHOP RATE LABOR GUIDE
3. WELDING WILL BE DETERMINED AT TIME OF NEED
4. PLUG A TUBLESS TIRE CHARGE IS $7.50 ON MOWER , OFF WILL BE $12.50 EACH TIRE
5. REMOVE TIRE ON RIM AND REPLACE $25.00 EACH SAME FEE FOR REPLACING TUBE
6. SHARPEN MOWER BLADES ON MOWER $10.00. IF I HAVE TO REMOVE BLADE $15.00 IF YOU REMOVE SHARPEN BLADE IS $7.00
IF YOUR SURE ON WHAT YOU NEED THEN YOU NEED TO SUPPLY ME WITH INFORMATION ON YOUR MOWER LIKE MAKE, MODEL, SER#. MOST CAN BE FOUND ON REAR OF MOWER ON FRAME OR UNDER THE SEAT. ALSO WILL NEED THE ENGINE INFO MAKE, MODEL, TYPE, AND CODE. THIS IS LOCATED ON THE ENGINE BRIGGS AND STRATTON MOST OF THEM IS ON THE ROCKER ARM COVER , LOOK ON THE SIDE OF THE BLOCK FOR OTHERS.
THIS WILL HELP ME MAKE SURE I HAVE ALL THE PARTS NEEDED TO PREFORM WHAT YOU WANT DONE.
IF YOU HAVE A SMART PHONE YOU CAN TAKE A PICTURE OF THE INFO AND E-MAITL IT TO ME OR TEXT IT TO 941-548-9723 ,